The storage is provisioned from the VNX as LUNs, that appear as managed disks (Mdisks) on the SVC, which can use them to create storage pools (MDiskgroups) to provision SVC volumes (VDisks) for use by hosts or for use with tiering.Įxample of an EMC VNX controller under SVC There is also a CLI access via NaviCLI from an installed host. There is the EMC Unisphere for web enabled remote management. See the following website for specific firmware levels and the supported hardware of a release: -Ĭoncurrent firmware upgrades (NDU) are supported for all VNX storage systems as per EMC VNX procedures. VNX OE R33 (05.33) and higher software only runs on the following VNX2 models: VNX5400, VNX5600, VNX5800, VNX7600, and VNX8000. SVC supports, VNX OE R31 (05.31) and higher controller firmware. VNX2: VNX5400, VNX5600, VNX5800, VNX7600, VNX8000įor support greater than 2TB EMC VNX LUNs size, support is from 7.3.0.5 onwards. The VNX family of storage systems consists of the following models: Note EMC CLARiiON CX systems are also earlier model equivalents for general settings.ĭifferent models of the EMC VNX are supported for use with the IBM SVC This portion of the document covers the necessary configuration for EMC VNX storage systems with an IBM SAN Volume Controller.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |